RUINKIT — PRINT GUIDE
=====================
Scale: 28-32 mm tabletop miniatures (heroic scale). Walls are 60 mm tall, 8 mm thick,
on a 3 mm base strip that is 14 mm deep. Straight walls end flush, so pieces line up.

FDM (Bambu, Prusa, Creality...):
- Print standing up, exactly as the file is oriented. No supports needed.
- 0.12-0.16 mm layer height, 0.4 mm nozzle, 3 walls, 15% infill.
- Arch tops of windows and doors bridge without supports.
- A brim is optional; tall 100 mm walls stand fine on the 14 mm base.

Resin:
- Print flat or angled 30-45 degrees with light supports on the back face.
- Pieces are solid; you can hollow them, leaving drain holes in the base.

Magnet holes (files in the "magnets" folder):
- Sized for the magnet named in the file name + 0.3 mm play, 0.25 mm extra depth.
- Press-fit, or add a drop of super glue. Check polarity before gluing a whole table!

Painting tip: black or dark brown primer, heavy drybrush of warm grey, then a
lighter drybrush on the edges. The mortar lines pick up a wash very well.

Every file is a closed (manifold) mesh, checked automatically before release.
Made with RuinKit, a free tool by Pacix Labs: https://www.pacixlabs.com/ruinkit/
